Click image to view original image
| Product Alias: | Bale Press Hydraulic Bundler | In stock: | Yes |
| Processing customization: | Yes | Packaging Materials: | Film |
| Package Type: | Other | Applicable to: | Apparel, Cereal, Teabag, Cotton, metal |
| Applicable industries: | Apparel, Home Textiles | Material Type: | Solid |
| 10 tons: | Single Cylinder | 40 tons: | Twin Cylinder |
| 20 tons: | Single Cylinder | 30 tons: | Single Cylinder |
| Yield: | 100 |
Detailed introduction of "soft foam hydraulic baler clothes baler sponge vertical hydraulic baler"
The vertical hydraulic baler reduces the floor space and can effectively prevent the cylinder from being damaged by external force, and the speed of delivery quick.
Instructions for the use of hydraulic balers:
1. First pass the packing rope through the rope slot under the baler, and place it along the packing belt slot. , leave enough length of strapping rope at both ends, and then close the front and rear doors.
2. Input the material, when the material is loaded to the height of the upper platen, press down on the reversing valve, Wait until the upper platen is pressed to the low end. Then lift the operating lever up to make the upper platen return to the top, and compact the material several times. (The feeding height of materials other than cardboard can only be slightly higher than the bottom door).
3. Open the equipment door after the material is compacted, and pass the packing rope from the front to the back through the rope slot of the upper platen Thread through and tie the knot tightly by hand. After fixing, lift the operating lever upward to make the upper platen return to the top. (When opening the lower door, no one is allowed to stand in front of the door, so as to avoid accidental injury when the door is opened)
4. Use wire rope to turn over the package or push the package and remove the package, close the door and lock it to enter the next package bundling.
Analysis of common faults of hydraulic balers:
The hydraulic baler does not work, the motor is still running. The main reason is: the running direction of the motor is reversed, check the rotation direction of the motor. Motor voltage is too low to operate properly with existing load, check voltage; check hydraulic lines for hose leaks or pinched. Check the pump coupling to make sure that the keyway can not leave the pump shaft; check whether the hydraulic oil in the tank is sufficient (the liquid level should be above 1/2 of the tank volume;) The suction filter of the tank or the breather cap on the top may be plugged. Check for loose suction line fittings, capillary cracks in pump suction port, suction line should always have oil and no air bubbles.
